Overview; Ipsetup Software Utility; Initial Configuration - NetBurner SBL2e User Manual

1. Overview

The NetBurner SBL2e is a dual serial-to-Ethernet device that will enable your serial device to
communicate on an Ethernet network using TCP or UDP. In addition to the serial capabilities, the
SBL2e also provides a separate network connection command channel for control of digital I/O
signals and analog-to-digital readback. A list of features and functions is below:
 2 Serial UARTs, TTL level, baud rates from 300 to 115,200
 4 12-bit analog to digital converters, 0-3.3VDC input
 Up to 10 Digital inputs/outputs, also referred to as GPIO
 10/100 Ethernet
 Serial to Ethernet capability through TCP or UDP
 DHCP and Static IP addressing
 Custom data packetization options
 Web page configuration
 AT command set configuration and operation
 3.3VDC input power @ 250mA max

2. IPSetup Software Utility

Setup and configuration of your SBL2e requires the IPSetup.exe Windows PC utility available for
download at www.netburner.com, in the Support > Public Downloads section:
http://www.netburner.com/support/public_downloads.html

3. Initial Configuration

Before you can begin using your SBL2e, three areas of configuration are required to tell your
SBL2e what type of serial interface you want to use, the network IP address network port number,
and the serial data baud rate.
1. Hardware configuration
2. Network configuration
3. Operational configuration
SBL2e Dual Serial-to-Ethernet User's Manual
Downloaded from Elcodis.com electronic components distributor
Page 4