Table of Contents
Advertisement
8.4.1 Custom Packetization
The custom packetization settings provide control over when serial data is packetized and sent to
the destination network host. You can configure the SBL2e to send serial data after a certain
number of characters have been received, a certain amount of time has expired, or upon receipt of a
specific character.
Example: AT#SER0LNPE=1<cr>
PE=<0 | 1>
PN=<1-128>
PT=<0–32768>
PC=<hex char>
Return Values:
A „?‟at the end of the command will return the setting. For example, AT#PE?<cr> will
return a value of 0 or 1.
SBL2e Dual Serial-to-Ethernet User's Manual
Downloaded from
Elcodis.com
electronic components distributor
// enable packetization options
0 = disable packetization, 1 = enable
Number of serial characters to accumulate
before sending a packet.
Number of milliseconds since last character to
wait before sending a packet. A value of 0
waits forever.
Sends all accumulated serial data upon receipt
of the specified ASCII character. The character
value must be entered as a hexadecimal number.
Page 23
Advertisement
Table of Contents
