Outgoing Connections (Client Mode) - NetBurner SBL2e User Manual

4.3 Outgoing Connections (Client Mode)

Make outgoing connections
Connect on network port
Connect to this address
Timeout and disconnect after this many
seconds of inactivity.
Retry failed outgoing connections after
this many seconds.
SBL2e Dual Serial-to-Ethernet User's Manual
Downloaded from Elcodis.com electronic components distributor
Selects between connect on power-up for a permanent
TCP connection, or make a TCP connection when
serial data available. This feature has no effect on
UDP.
Specifies destination TCP or UDP port number
Specifies destination IP address for TCP or UDP.
When using UDP you must specify an address and port
number in this section, or enable the Learn UDP Reply
Address feature in the Custom Packetization section.
Terminate TCP connection if no incoming network
data or outgoing serial data has occurred. This is useful
because there is no way to detect if a client has crashed
or abnormally terminated unless unacknowledged data
exists and times out. A value of 0 disables this feature.
This feature has no effect on UDP.
Number of seconds to wait before retrying an outgoing
connection. This feature has no effect on UDP.
Page 9