At Command Examples; Changing The System Ip Address; Configuring The Serial Server Listen Port; Configure Outgoing Network Client Connection - NetBurner SBL2e User Manual

8.6 AT Command Examples

The following examples display the full transcript of serial communication including commands
sent and replies from the SBL2e. Commands are marked in

8.6.1 Changing the System IP Address

This example first queries the current IP address, and then changes the current IP to 10.1.1.79. Once
the IP address change request is made, the settings are saved, and the device reboots.
+++
OK>AT#CURIP?10.1.1.99
OK>AT#SYSIP=10.1.1.79
OK>AT&PIP Address Changed Rebooting
Waiting 2sec(s) to start 'A' to abort

8.6.2 Configuring the Serial Server Listen Port

This example first queries the current TCP Serial Server listening port number, and then changes
the current port number to 30. Once the port number change request is made, the settings are saved.
No system restart was required.
+++
OK>AT#SER0SP?23
OK>AT#SER0SP=30
OK>AT&P2,Returning to listening connection

8.6.3 Configure Outgoing Network Client Connection

This example changes the client connection‟s IP and port. Once the changes are made, the settings
are saved. No system restart was required.
+++
OK>AT#SER0CI=10.1.1.78
OK>AT#SER0CP=30
OK>AT&P2,Returning to listening connection
SBL2e Dual Serial-to-Ethernet User's Manual
Downloaded from Elcodis.com electronic components distributor
red, responses are marked in
Page 25
blue.