Incoming Connections (Server Mode) - NetBurner SBL2e User Manual

4.2 Incoming Connections (Server Mode)

This section configures the SBL2e in a device server mode in which it listens for incoming TCP
connections (or UDP packets if enabled) for each serial port.
Listen for incoming network
connections
Listening network port
Timeout and disconnect after this many
seconds of inactivity.
Allow new connection if the existing
connection has been idle for this many
seconds.
SBL2e Dual Serial-to-Ethernet User's Manual
Downloaded from Elcodis.com electronic components distributor
Select checkbox to enable the port to listen for
incoming TCP connection requests or UDP packets.
Checking this box will override the TCP Client mode.
Port number to listen on. The default port is 23 (telnet).
The listen port numbers for Port0 and Port1 must be
different.
Terminate TCP connection if no incoming network
data or outgoing serial data has occurred. This is useful
because there is no way to detect if a client has crashed
or abnormally terminated unless unacknowledged data
exists and times out. A value of 0 disables this feature.
This field has no effect in UDP mode.
Similar to the disconnect timeout, but does not
disconnect a connection until a new connection is
requested. A value of 0 disables this feature. This field
has no effect in UDP mode.
Page 8