Table of Contents
Advertisement
Installation of Flare-less Bite type and Flared connections
1. Remove protective connector caps only immediately
prior to assembly.
2. Inspect the components to ensure that the male and
female threads and sealing surfaces are free of burrs,
nicks, and scratches, or any foreign material. Do not
use if impurities are found.
3. Place the face of the female connector against the face
and O-ring of the male connector.
4. Thread the nut completely onto the male connector by
hand.
5. Complete steps 1 through 5 for both ends of the hose
or tube before continuing.
6. Hand-tighten any clamps that hold the position of the
hose or tube.
7. Tighten the connection to the proper torque value. See
the torque tables for the proper torque value.
8. Complete tightening of any clamps that hold the hose
or tube only after both end fittings have been fully tight-
ened.
INTRODUCTION
48048569 26/04/2017
29
6
RAIL15TLB0541AA
Advertisement
Table of Contents
