Safety Rules - Personal Safety - New Holland D150C Service Manual

Safety rules - Personal safety

D150C
General maintenance safety
Keep area used for servicing the machine clean and dry. Clean up spilled fluids.
Service machine on a firm level surface.
Install guards and shields after servicing the machine.
Close all access doors and install all panels after servicing the machine.
Do not attempt to clean, lubricate, clear obstructions or make adjustments to the machine while it is in motion or while
the engine is running.
Always make sure working area is clear of tools, parts, other persons and pets before you start operating the machine.
Unsupported hydraulic cylinders can lose pressure and drop the equipment causing a crushing hazard. Do not leave
equipment in a raised position while parked or during service, unless securely supported.
Jack or lift the machine only at jack or lift points indicated in this manual.
Incorrect towing procedures can cause accidents. When towing a disabled machine follow the procedure in this man-
ual. Use only rigid tow bars.
Stop the engine, remove key and relieve pressure before disconnecting or connecting fluid lines.
Stop the engine and remove key before disconnecting or connecting electrical connections.
Scalding can result from incorrect removal of coolant caps. Cooling system operates under pressure. Hot coolant
can spray out if a cap is removed while the system is hot. Allow system to cool before removing cap. When removing
a cap turn it slowly to allow pressure to escape before completely removing the cap.
Replace damaged or worn tubes, hoses, electrical wiring, etc.
Engine, transmission, exhaust components, and hydraulic lines may become hot during operation. Take care when
servicing such components. Allow surfaces to cool before handling or disconnecting hot components. Wear protective
equipment when appropriate.
When welding, follow the instructions in the manual. Always disconnect the battery before welding on the machine.
Always wash your hands after handling battery components.
General battery safety
Always wear eye protection when working with batteries.
Do not create sparks or have open flame near battery.
Ventilate when charging or using in an enclosed area.
Disconnect negative (-) first and reconnect negative (-) last.
When welding on the machine, disconnect both terminals of the battery.
Do not weld, grind, or smoke near a battery.
When using auxiliary batteries or connecting jumper cables to start the engine, use the procedure shown in the oper-
ator's manual. Do not short across terminals.
Follow manufacturer's instructions when storing and handling batteries.
Battery post, terminals, and related accessories contain lead and lead compounds. Wash hands after handling. This
is a California Proposition 65 warning.
INTRODUCTION
ANZ --- APAC --- LA --- MEA
48048569 26/04/2017
5
Find manuals at https://best-manuals.com