Table of Contents
Advertisement
Setting up
Connecting with your devices (continued)
RS-232C
External
device
WARNING
possible burns disconnect the projector power cord for 10 minutes before
touching the adapter.
CAUTION
the consent of the administrator of the network.
►Do not connect the LAN port to any network that might have the excessive voltage.
►The designated USB wireless adapter sold as an option is required to use the
wireless network function of this projector. Before connecting the USB wireless
adapter, turn off the power of the projector and disconnect the power cord. Do not
use any extension cable or device when connecting the adapter to the projector.
►To connect both the LAN cable and USB wireless adapter to the projector, use
a LAN cable that is fl at on the side where the plug's wire is visible. Otherwise,
both of them cannot be connected correctly, or the wire may break (malfunction).
• If an oversized USB storage device blocks the LAN port, use a USB extension
cable to connect the USB storage device.
About HDBaseT™
• HDBaseT is a technology to transmit image, sound, ethernet or serial control
signal using a LAN cable.
• LAN or HDBaseT input port can be selected as ethernet signal input by
switching in the menu.
• Use LAN cables of up to 100m long. Up to 70m long for 4K signal. Exceeding
this length, the image and sounds are deteriorated, and even experience
malfunction on LAN transmission.
(continued on next page)
RS-232C
►Heat may build up in the USB wireless adapter, to avoid
► Before connecting the projector to a network system, obtain
connection
LAN
Computer
3 0
USB wireless
adapter
(optional)
Access
point
QM00971-1
Advertisement
Table of Contents
