Table of Contents
Advertisement
Troubleshooting
Issues that may be easy to be mistaken for machine defects (continued)
Issue
Pictures appear
blurry.
Some kind
of image
degradation
such as
flickering or
stripes appear
on screen.
RS-232C does
not work.
(continued on next page)
Cases not involving a machine defect
The lens cover is attached.
Remove the lens cover.
Either the focus and/or horizontal phase settings are
not properly adjusted.
Adjust the focus using the FOCUS + / - buttons on
the remote control or FOCUS button and ◄/► cursor
buttons on the projector, and/or H PHASE using the
menu function.
The lens is dirty or misty.
Clean the lens referring to the section Caring for the lens.
When the projector is operating in LONG LIFE 1,
LONG LIFE 2 or WHISPER, flickering may appear on
screen.
Set LIGHT OUTPUT in the LIGHT & FILTER menu to
NORMAL(100).
The OVER SCAN ratio is too big.
Adjust OVER SCAN in the IMAGE menu smaller.
Excessive VIDEO NR.
Change the setting of VIDEO NR in the INPUT menu.
The FRAME LOCK function cannot work on the
current input signal.
Set FRAME LOCK in the INPUT menu to OFF.
The SAVING/NETWORK(WOL) function is working.
Select NORMAL or QUICK START for STANDBY MODE
item in the SETUP menu.
The COMMUNICATION TYPE for the CONTROL port
is set to NETWORK BRIDGE.
Select OFF for COMMUNICATION TYPE item in the
OPTION - SERVICE - COMMUNICATION menu.
14 0
Reference
page
–
4 9, 76
12 7
8 4
75
77
8 0
8 7
111
QM00971-1
Advertisement
Table of Contents
