Addressing The Tv-Ucxp683T-V Through The Service Port - Carrier TruVu UCXP683T-V Installation And Startup Manual

Addressing the TV-UCXP683T-V through the Service port

The TV-UCXP683T-V is addressed using the controller setup pages. The Local Network tab allows you to discover
all i-Vu® XT or TruVu™ devices on a single network and configure them from that page. See Addressing a network
of controllers using the controller setup Local Network tab (page 13) and the Local Network (page 51) tab.
You can connect the TV-UCXP683T-V to a computer one of two ways.
NOTE You cannot access the Service port by plugging an Ethernet cable into Eth0 or Eth1.
To connect the TV-UCXP683T-V to a computer using the Carrier wireless service adapter.
Insert the Carrier wireless service adapter (part# USB-W) into the controller's USB Service Port to
1
communicate with a Wi-Fi-compatible computer.
CAUTION If the Eth1 port is in use, connect a USB Type-A Male to Female extension cable to the USB
Service Port and the Carrier wireless service adapter.
Open your computer's wireless network display to view your available wireless networks.
2
NOTE TV-UCXP683T-V only supports the 5 GHz band and not the 2.4 GHz band.
Connect to the wireless network using the network SSID and password that are printed on the Carrier
3
wireless service adapter.
Open a web browser on the computer and navigate to http://local.access or http://169.254.1.1 to see the
4
controller setup pages.
TruVu™ UCXP683T-V
Installation and Start-up Guide
Addressing the TV-UCXP683T-V through the Service port
9
CARRIER CORPORATION ©2021
All rights reserved