Addressing The Tv-Uc561 Through The Service Port - Carrier TruVu UC561 Installation And Startup Manual

Addressing the TV-UC561 through the Service port

The TV-UC561 is addressed using the controller setup pages. The Local Network tab allows you to discover all i-
Vu® XT or TruVu™ devices on a single network and configure them from that page. See Addressing a network of
controllers using the controller setup Local Network tab (page 12) and the Local Network (page 45) tab.
You can connect the TV-UC561 to a computer using either the Carrier wireless service adapter or a USB cable.
NOTE You cannot access the Service port by plugging an Ethernet cable into Eth0 or Eth1.
To connect the TV-UC561 to a computer using the Carrier wireless service adapter.
Insert the Carrier wireless service adapter (part# USB-W) into the controller's USB Service Port to
1
communicate with a Wi-Fi-compatible computer.
CAUTION If the Eth1 port is in use, connect a USB Type-A Male to Female extension cable to the USB
Service Port and the Carrier wireless service adapter.
Open your computer's wireless network display to view your available wireless networks.
2
NOTE TV-UC561 only supports the 5 GHz band and not the 2.4 GHz band.
Connect to the wireless network using the network SSID and password that are printed on the Carrier
3
wireless service adapter.
Open a web browser on the computer and navigate to http://local.access or http://169.254.1.1 to see the
4
controller setup pages.
TruVu™ UC561
Installation and Start-up Guide
Addressing the TV-UC561 through the Service port
9
CARRIER CORPORATION ©2021
All rights reserved