CONTENTS Read before installation and use Safety instructions List of components Assembly instructions Tools needed User guide Purpose General instructions for use Product specifications Care and maintenance Preventive maintenance and inspections Spare parts and service Warranty...
Install and use this equipment in a place where access and supervision are specifically controlled by the owner. Be sure to install the equipment on a stable base and level the equipment properly. Eleiko recommends that all equipment is installed by a licensed contractor or an Eleiko installer.
Page 5
LIST OF COMPONENTS ARP Black Bonded Foam Rubber Tile 666x685x12,7 mm 666x695x70 mm 2000802 2001901 2000820 Bonded Foam Bonded Foam 2000x975x70 mm 1270x1000x70 mm 2001450 2001371 2001358 2001451 - 5 -...
ASSEMBLY INSTRUCTIONS Before assembly, make sure you have enough clearance on all sides of the equipment, not less than 0,6 meters. Take in account the accessibility to remove and replace bar and weights. TOOLS NEEDED You need the following tools to assemble the equipment. Torx Wrench Tape Measure Allen Key Size 5...
Page 7
Remove the two end plates from the front floor beams. - 7 -...
Page 8
Bonded Foam Bonded Foam 1270x1000x70 mm 2000x975x70 mm 2001371 2001450 LEAVE A SMALL GAP BETWEEN RACK AND BONDED FOAM! 2001371 2001450 - 8 -...
Page 9
2001358 2001451 CAREFULLY PLACE THE WOODEN PLATFORM IN THE RACK, STANDING DECK FACING UP! 2001358 2001451 LEAVE A SMALL GAP BETWEEN RACK AND PLATFORM! - 9 -...
Page 10
2001561 SLIDE THE FLAT IRON INTO THE GROOVE IN THE WOODEN PLATFORM, MAKE SURE THE HOLE IN THE FLAT IRON IS TO THE LEFT, THE SAME SIDE AS THE CUT OUT IN THE WOODEN PLATFORM! - 10 -...
USER GUIDE PURPOSE Reduce noise, dampen vibration and minimize bounce. GENERAL INSTRUCTIONS FOR USE Only drop weights on dropzone. Stand on the lifting deck when lifting. PRODUCT SPECIFICATION Product weight 315 kg / 694 lbs Dimensions (L x W x H) 3324 x 2465 x 102 mm 130,87 x 97,05 x 4,02"...
E-mail: info@eleiko.com | Phone: +46 35 17 70 70 WARRANTY All products manufactured by ELEIKO are warranted to the original purchaser to be free from defects in workmanship and / or materials under normal use or service as follows: · 10 years on structural frame welds (NOT on moving parts) Normal wear and tear do not fall under the 10-year warranty.
Page 24
Eleiko Group AB | Klastorpsvägen 18 | SE-302 62 HALMSTAD | Sweden E-mail: info@eleiko.com | Phone: +46 35 17 70 70 www.eleiko.com...
Need help?
Do you have a question about the SVR INSERT PLATFORM PRESTERA HALF RACK LARGE and is the answer not in the manual?
Questions and answers