CONTENTS Read before installation and use Safety instructions List of components Assembly instructions Tools needed User guide Purpose General instructions for use Product specifications Care and maintenance Preventive maintenance and inspections Spare parts and service Warranty...
Install and use this equipment in a place where access and supervision are specifically controlled by the owner. Be sure to install the equipment on a stable base and level the equipment properly. Eleiko recommends that all equipment is installed by a licensed contractor or an Eleiko installer.
Page 5
LIST OF COMPONENTS Bonded Foam ARP Black 666x695x70 mm 666x685x12,7 mm Rubber Tile 2000820 2001901 2000803 Bonded Foam Bonded Foam 500x1000x70 mm 1330x975x70 mm 2001429 2001363 2001357 2001428 - 5 -...
ASSEMBLY INSTRUCTIONS Before assembly, make sure you have enough clearance on all sides of the equipment, not less than 0,6 meters. Take in account the accessibility to remove and replace bar and weights. TOOLS NEEDED You need the following tools to assemble the equipment. Torx Wrench Socket Wrench Size 17mm Socket Wrench Size 24mm...
Page 7
Remove the two end plates from the front floor beams. - 7 -...
Page 8
Bonded Foam Bonded Foam 1330x975x70 mm 500x1000x70 mm 2001363 2001429 LEAVE A 3,5 CM GAP BETWEEN BONDED FOAM AND RACK! 2001429 2001363 - 8 -...
Page 9
2001357 2001428 CAREFULLY PLACE THE WOODEN PLATFORM IN THE RACK, STANDING DECK FACING UP! 2001357 2001428 - 9 -...
Page 10
2001561 SLIDE THE FLAT IRON INTO THE GROOVE IN THE WOODEN PLATFORM, MAKE SURE THE HOLE IN THE FLAT IRON IS TO THE LEFT, THE SAME SIDE AS THE CUT OUT IN THE WOODEN PLATFORM! - 10 -...
USER GUIDE PURPOSE Reduce noise, dampen vibration and minimize bounce. GENERAL INSTRUCTIONS FOR USE Only drop weights on dropzone. Stand on the lifting deck when lifting. PRODUCT SPECIFICATION Product weight 226 kg / 498 lbs Dimensions (L x W x H) 2411 x 2465 x 102 mm 94,92 x 97,05 x 4,02"...
E-mail: info@eleiko.com | Phone: +46 35 17 70 70 WARRANTY All products manufactured by ELEIKO are warranted to the original purchaser to be free from defects in workmanship and / or materials under normal use or service as follows: · 10 years on structural frame welds (NOT on moving parts) Normal wear and tear do not fall under the 10-year warranty.
Page 24
Eleiko Group AB | Klastorpsvägen 18 | SE-302 62 HALMSTAD | Sweden E-mail: info@eleiko.com | Phone: +46 35 17 70 70 www.eleiko.com...
Need help?
Do you have a question about the SVR INSERT PLATFORM PRESTERA DOUBLE HALF RACK SMALL and is the answer not in the manual?
Questions and answers