Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Eleiko SVR INSERT PLATFORM PRESTERA HALF RACK
Summary of Contents for Eleiko SVR INSERT PLATFORM PRESTERA HALF RACK
- Page 1 ELEIKO SVR INSERT PLATFORM PRESTERA HALF RACK - SMALL Art.no. 3085517...
-
Page 2: Table Of Contents
CONTENTS Read before installation and use Safety instructions List of components Assembly instructions Tools needed User guide Purpose General instructions for use Product specifications Care and maintenance Preventive maintenance and inspections Spare parts and service Warranty... -
Page 3: Read Before Installation And Use
Install and use this equipment in a place where access and supervision are specifically controlled by the owner. Be sure to install the equipment on a stable base and level the equipment properly. Eleiko recommends that all equipment is installed by a licensed contractor or an Eleiko installer. -
Page 4: List Of Components
LIST OF COMPONENTS 2001362p1 2000687 p1 2000687 p2 2001370 2001368 2001369 2001365 2001366 2000688 a1 2001561 M10x25 M6S M10x80 2001367 2000719 2000688 p2 2001124-L25 2001385-L80 - 4 -... - Page 5 LIST OF COMPONENTS Bonded Foam ARP Black 666x695x70 mm 666x685x12,7 mm Rubber Tile 2000820 2001901 2000803 Bonded Foam Bonded Foam 1270x1000x70 mm 1330x975x70 mm 2001371 2001363 2001357 2001358 - 5 -...
-
Page 6: Assembly Instructions
ASSEMBLY INSTRUCTIONS Before assembly, make sure you have enough clearance on all sides of the equipment, not less than 0,6 meters. Take in account the accessibility to remove and replace bar and weights. TOOLS NEEDED You need the following tools to assemble the equipment. Torx Wrench Allen Key Size 5 Socket Wrench Size 17mm... - Page 7 Remove the two end plates from the front floor beams. - 7 -...
- Page 8 Bonded Foam Bonded Foam 1330x975x70 mm 1270x1000x70 mm 2001363 2001371 LEAVE A SMALL GAP BETWEEN RACK AND BONDED FOAM! 2001371 2001363 - 8 -...
- Page 9 2001358 2001357 CAREFULLY PLACE THE WOODEN PLATFORM IN THE RACK, STANDING DECK FACING UP! 2001358 2001357 LEAVE A SMALL GAP BETWEEN RACK AND PLATFORM! - 9 -...
- Page 10 2001561 SLIDE THE FLAT IRON INTO THE GROOVE IN THE WOODEN PLATFORM, MAKE SURE THE HOLE IN THE FLAT IRON IS TO THE LEFT, THE SAME SIDE AS THE CUT OUT IN THE WOODEN PLATFORM! - 10 -...
- Page 11 2001370 2001368 2001369 - 11 -...
- Page 12 2001367 2001365 M10x25 2001366 LOOSE SCREWS! - 12 -...
- Page 13 2000719 M6S M10x80 CLOSE THE GAP BETWEEN RACK AND PLATFORM FIRST! LOOSE SCREWS! - 13 -...
- Page 14 ARP Black Bonded Foam 666x685x12,7 mm 666x695x70 mm Rubber Tile 2001901 2000820 2000803 2001901 2000820 - 14 -...
- Page 15 2001362p1 SMALLER HOLE TOWARDS RACK! - 15 -...
- Page 16 2000688 a1 2000688 p2 M10x25 LOOSE SCREWS! - 16 -...
- Page 17 2000687 p1 - 17 -...
- Page 18 2000687 p2 - 18 -...
- Page 19 TIGHTEN FRAME AND SCREWS! - 19 -...
-
Page 20: User Guide
USER GUIDE PURPOSE Reduce noise, dampen vibration and minimize bounce. GENERAL INSTRUCTIONS FOR USE Only drop weights on dropzone. Stand on the lifting deck when lifting. PRODUCT SPECIFICATION Product weight 238 kg / 525 lbs Dimensions (L x W x H) 2653 x 2465 x 102 mm 104,45 x 97,05 x 4,02"... -
Page 21: Care And Maintenance
E-mail: info@eleiko.com | Phone: +46 35 17 70 70 WARRANTY All products manufactured by ELEIKO are warranted to the original purchaser to be free from defects in workmanship and / or materials under normal use or service as follows: · 10 years on structural frame welds (NOT on moving parts) Normal wear and tear do not fall under the 10-year warranty. - Page 24 Eleiko Group AB | Klastorpsvägen 18 | SE-302 62 HALMSTAD | Sweden E-mail: info@eleiko.com | Phone: +46 35 17 70 70 www.eleiko.com...
Need help?
Do you have a question about the SVR INSERT PLATFORM PRESTERA HALF RACK and is the answer not in the manual?
Questions and answers