Turning The Power On/Off; Turning The Power On; Turning The Power Off - Furuno FSV-24 Operator's Manual

1. OPERATIONAL OVERVIEW
1.2

Turning the Power On/Off

1.2.1

Turning the power on

Press the POWER ON (|) switch. A beep sounds, the lamp above the switch
lights, and the last-used mode is presented.
1.2.2

Turning the power off

1. First retract the transducer with the [ ] key. The lamp above the switch blinks
while the transducer is being raised and lights steadily when it is fully raised.
Note: While raising the transducer, the ship speed speed must be as below
2. Press the POWER OFF (
key lights steadily.
Note: The transducer is automatically retracted into the tank if the POWER OFF
(
safety purposes, make it a habit to retract the transducer before turning off
the power.
1-2
to prevent damage to the transducer.
1200 mm stroke: 12 kts or less
1600 mm stroke: 15 kts or less
) switch is pressed before retracting the transducer. However, for
POWER
POWER OFF key
POWER ON key
Figure 1-2 POWER & TRANSDUCER key
) switch for more than one second, after the [ ]
TRANSDUCER
Mid protrusion key
Retraction key
Full protrusion key