10.11.2 Raising The Transducer Manually - Furuno FSV-24 Operator's Manual

10.11.2 Raising the transducer manually

1. Open the lid on the hull control unit and turn off the motor breaker on the hull
control unit. Confirm that the light on the power supply indicator is off. (See
the illustration on the previous page for location of motor breaker and power
supply indicator.)
2. Referring to the illustration below, unscrew two screws on the cover, and then
remove the cover.
3. Pull the release lever toward you, and raise it to upper side to release the
brake.
4. Attach the hand crank to the motor shaft.
5. Turn the handle clockwise to raise the transducer.
Also, you can raise the transducer with wrench using the socket (attached on the
hull unit with hand crank).
Note: Be sure to put back the lever to the holder after completing manual
raising/lowering operation. If not, the brake will be left released, and then
the transducer may drop by its own weight.
COVER
RELEASE LEVER
HOLDER
Figure 10-10 How to raise the transducer manually
10. MAINTENANCE, TROUBLESHOOTING
SCREWS
HAND CRANK
LOWER
RAISE
MOTOR
UP
10-13