Rear A-Arm Installation - Polaris RANGER EV 2015 Service Manual

8. Remove the fastener attaching the lower A-arm to
the bearing carrier.
9. Remove the fasteners attaching the lower A-arm to
the frame and remove the lower A-arm from the
vehicle.
10. Examine A-arm and bearing carrier bushings and
pivot tubes (see "Exploded View"). Replace if worn.
Discard hardware.
WARNING
The locking agent on the existing bolts was destroyed
during removal. DO NOT reuse old hardware. Serious
injury or death could result if fasteners come loose
during operation.
11. If not replacing the A-arm, thoroughly clean the a-
arm and pivot tubes.
12. Insert new A-arm bushings and pivot tubes into the
new A-arm.
9926595 R01 - 2015-2016 RANGER EV Service Manual
© Copyright Polaris Industries Inc.
BODY / STEERING / SUSPENSION

REAR A-ARM INSTALLATION

1. Install lower A-arm assembly onto vehicle frame.
Torque new fasteners to specification.
TORQUE
A-Arm Fasteners:
30 ft-lb (41 Nm)
2. Attach lower A-arm to bearing carrier. Torque new
fastener to specification.
TORQUE
A-Arm Fasteners:
30 ft-lb (41 Nm)
3. Route the brake line over the top of the lower A-arm
and secure it in the retainer.
4. Install upper A-arm assembly onto vehicle frame.
Torque new fasteners to specification.
TORQUE
A-Arm Fasteners:
30 ft-lb (41 Nm)
5. Attach upper A-arm to bearing carrier. Torque new
fastener to specification.
TORQUE
A-Arm Fasteners:
30 ft-lb (41 Nm)
6. Reinstall the lower portion of the shock and stabilizer
linkage to the upper A-arm. Torque shock / linkage
fastener to specification.
TORQUE
Shock Fastener:
30 ft-lb (41 Nm)
4
4.21