Craftsman PRO Series Operator's Manual page 7

4. Pivot the upper handle into position and using the carriage screws (a) and
flange lock nuts (b) removed in step 1, secure the handle in place. See Figure 4.
(a)
5. Re-tighten the upper carriage screws (a) and flange lock nuts (b) from step 1.
6. Remove lock nuts (a) and hex screws (b) from chute support bracket (this will
require two wrenches). See Figure 5.
(a)
1
(a)
Chute Assembly
Chute Base
(b)
(b)
Figure 4
Chute Control Head
2
(b)
1
(b)
Chute Support
Bracket
Figure 5
ASSEMBLY
7. Place chute assembly onto chute base and chute control head onto chute
support bracket. See Figure 5.
8. Secure chute control head to chute support bracket with lock nuts (a) and
hex screws (b) removed in Step 1. See Figure 2-7.
(a)
(a)
(a)
9. Remove hairpin clip (a) from rear of chute control assembly. See Figure 7.
7
(b)
Figure 6
(a)
(b)
Figure 7
(b)