Craftsman PRO Series Operator's Manual page 11

3. With drive control lever released, push unit gently forward. It should roll
freely.
4. Engage drive control lever and gently attempt to push the unit forward. The
wheels should not turn. The unit should not roll freely.
5. If equipped with a shift lever, with drive control lever released, move shift
lever back and forth between the R2 position and the F6 position several
times. There should be no resistance in the shift lever.
6. If any of the above tests failed, the drive cable is in need of adjustment.
7. Shut OFF engine. Refer to Stopping the Engine in the Operation section.
8. Loosen lower hex screw (a) on drive cable bracket (b). See Figure 16.
9. Position cable bracket (b) upward to provide more slack (or downward to
increase cable tension).
10. Retighten lower hex screw (a).
11. Check adjustment of drive control lever as described above to verify proper
adjustment has been achieved.
(b)
(a)
Figure 16
ASSEMBLY
11