Craftsman PRO Series Operator's Manual page 19

Chute Control Rod
To achieve more chute control rod engagement in the input shaft under the handle
panel, the chute control rod will have to be adjusted. Refer to Figure 24.
To adjust this rod, proceed as follows:
1. Remove the cotter pin from the hole closest to the chute control head on the
chute control input.
2. Pull out the chute control rod until the hole in it lines up with the other hole
in the chute control input.
3. Reinsert the cotter pin through this hole and the chute control rod.
SERVICE AND MAINTENANCE
Figure 24
Auger Control
Refer to the Assembly section for instructions on adjusting the auger control cable.
Skid Shoes
Refer to the Assembly section for instructions on adjusting the skid shoes.
Belt Replacement
Auger Belt
To remove and replace your snow thrower's auger belt, proceed as follows:
1. To prevent spillage, remove all fuel from tank by running engine until it
stops.
2. Remove the plastic belt cover on the front of the engine by removing the two
self-tapping screws. See Figure 25.
3. Roll the auger belt off the engine pulley. See Figure 26.
19
Figure 25
Figure 26