Craftsman PRO Series Operator's Manual page 17

Before performing any type of maintenance/service, disengage all controls
and stop the engine. Wait until all moving parts have come to a complete
stop. Disconnect spark plug wire and ground it against the engine to
prevent unintended starting.
Interval
Each Use and every 5 hours
1st 5 hours
Annually or 25 hours
Annually or 50 hours
Annually or 100 hours
Before Storage
Maintenance
Before performing any maintenance or repairs, disengage PTO, move shift
lever into neutral position, set parking brake, stop engine and remove key
to prevent unintended starting.
If the engine has been recently run, the engine, muffler and surrounding
metal surfaces will be hot and can cause burns to the skin. Exercise caution
to avoid burns.
Engine
Refer to the Engine Operator's Manual for engine maintenance instructions.
Check engine oil level before each use as instructed in this manual. See the Engine
Operator's Manual for oil change instructions. Follow the instructions carefully.
Lubrication
Gear Shaft
The gear (hex) shaft should be lubricated at least once a season or after every 25
hours of operation.
1. To prevent spillage, remove all fuel from tank by running engine until it
stops.
2. Carefully pivot the snow thrower up and forward so that it rests on the auger
housing.
3. Remove the lower frame cover from the underside of the snow thrower by
removing the self-tapping screws which secure it.
SERVICE AND MAINTENANCE
MAINTENANCE SCHEDULE
WARNING
Item
1. Engine oil level
2. Loose or missing hardware
3. Unit and engine.
1. Engine oil
1. Spark plug
2. Control linkages and pivots
3. Wheels
4. Gear shaft and Auger shaft
1. Engine oil
1. Spark plug
1. Fuel system
WARNING
WARNING
Follow the maintenance schedule given below. This chart describes service
guidelines only. Use the Service Log column to keep track of completed
maintenance tasks. To locate the nearest Sears Service Center or to schedule service,
call the following toll free number:1-888-331-4569.
Service
1. Check
2. Tighten or replace
3. Clean
1. Change (See Engine Manual)
1. Check (See Engine Manual)
2. Lube with light oil
3. Lube with multipurpose auto grease
4. Lube with light oil
1. Change (See Engine Manual)
1. Change (See Engine Manual)
1. Run engine until it stops from lack of fuel
4. Apply a light coating of anti-seize to the hex shaft. See Figure 20.
NOTE: When lubricating the hex shaft, be careful not to get any anti-seize on
the aluminum drive plate or rubber friction wheel. Doing so will hinder the snow
thrower's drive system. Wipe off any excess or spilled anti-seize.
Wheels
At least once a season, remove both wheels. Clean and coat the axles with a
multipurpose automotive grease before reinstalling wheels.
17
Service Log
Figure 20