BRAYER BR1122 Instruction Manual page 8

8 EN
• After the Flask (1) is filled with prepared coffee,
switch the Coffee Maker off by pressing the Knob
(13) again, the Light Indicator (14) will extinguish.
• To keep the coffee hot, leave the flask (1) on the tray
(10) and do not switch the coffee maker off.
Notes: - the keep warm time for ready coffee is limited
to 40 minutes, after that the coffee maker will switch off.
ATTENTION!
• When you don't need to keep the flask (1) warm,
always switch the coffee maker off by pressing the
Knob (13).
• Water passes through ground coffee under steam
pressure, so do not bend over the coffee maker,
do not open the lid (6) and do not remove the filter
holder (4) and the filter (5) during making coffee.
• Do not leave the empty coffee flask (1) on the flask
warming tray (10), otherwise the glass may crack.
PREPARING STRONG COFFEE
• To prepare strong coffee, set the Knob (13) to
"КРЕПКИЙ", the Indicator (16) will turn on, then set
the Knob (13) to "ВКЛ/ВЫКЛ", and press the Knob
(13) once - the Light Indicator (14) will turn red and
the Coffee Maker will switch on in the Strong Coffee
Mode.
Note: - to exit the Strong Coffee Mode, set the Knob
(13) to "КРЕПКИЙ" and press the Knob (13) once - the
Indicator (16) will extinguish.
COFFEE MAKER SWITCH-ON TIME
SETTING FUNCTION
• Open the lid (6).
• Measure the required amount of ground coffee and put
it into the filter (5). 6 grams of ground coffee per one
coffee cup is required on average; adjust the quantity
according to your taste.
• Fill the tank (7) with cold water up to the required level.
Determine the water level using the scale (8).
• Close the lid (6).
• Put the flask (1) on the tray (10).
• Insert the plug into the mains socket, the digital
flashing symbols «12:00» will appear on the display
(15).
• Set the current time if no current time is set. (see the
section «Setting current time»). Time format is 24
hours.
Example: - suppose the current time is 09:00 AM and
you wish to prepare coffee at 01:00 PM.
• Set the Knob (13) to "ТАЙМЕР", press the Knob (13)
once, the Light Indicator (14) will flicker green and the
Display (15) will show flickering symbols
• Set the Knob (13) to "ЧАСЫ" and set the "hours" value
to "13" by pressing the Knob (13).
• Set the Knob (13) to "МИН" and set the "minutes"
value to "00" by pressing the Knob (13).
• Set the Knob (13) to "ТАЙМЕР", press the Knob (13)
once, the Light Indicator (14) will flicker green, the