Replacing The Compressor - Invacare SoftCloud Top Service Manual

5. Loosen and remove the five screws F with the
appropriate Torx key.
6. Replace the nonfunctioning PCB and secure the
new one with the five provided screws.
7. Plug the power switch cable, motor, compressor,
and mains cables.
8. Plug the sensor tube E and secure it with a cable
tie. Cut the excess cable tie length.
9. Install the housing. Ensure no cable or tube is
kinked or clamped.

4.2.4 Replacing the Compressor

Refers to spare parts kit SP1631541
Risk of damaging the PCB by electro-
static discharge
Handle PCB's only in Electrostatic Protected
Areas
T20 Torx key
Wire clippers
1. Switch off the control unit and disconnect from
mains supply.
2. Detach the top housing, the speaker cable and
both FPC's (see 4.2.2).
3. Unplug the compressor cable from the PCB (see
4.2.3).
4. Using the wire clippers, cut the cable tie securing
the wires.
5. Carefully remove the cable tie securing the air
tube A and unplug the tube.
6. Loosen and remove the six screws B.
60129675-B
F
F
Fig. 4-19
A
Fig. 4-20
B
B
B
Fig. 4-21
Invacare ® SoftCloud TM
F
B
B
B
family
F
F
17