Installing The Mp-124; Unpacking; Package Contents; Mounting The Mp-124 - AudioCodes MP-124 Fast Track Manual

Analog Fast Track Guide
2.2

Installing the MP-124

1.
2.
3.
4.
After connecting the MP-124 to the power source, the Ready and LAN LEDs on the front panel
turn to green (after a self-testing period of about one minute). Any malfunction changes the
Ready LED to red.
When you have completed the above relevant sections you are then ready to start configuring the
gateway (Section
2.2.1

Unpacking

1.
2.
3.
4.
5.
6.
2.2.2

Package Contents

Ensure that in addition to the MP-124, the package contains:
2.2.3

Mounting the MP-124

The MP-124 can be mounted on a desktop or installed in a standard 19-inch rack. Refer to
Section
2.2.3.1

Mounting the MP-124 on a Desktop

No brackets are required. Simply place the MP-124 on the desktop in the position you require.
Version 5.0
http://ArtTel.ru
To install the MP-124, take these 4 steps:
Unpack the MP-124 (refer to Section
Check the package contents (refer to Section
Mount the MP-124 (refer to Section
Cable the MP-124 (refer to Section
3 on page 18).
To unpack the MP-124, take these 6 steps:
Open the carton and remove packing materials.
Remove the MP-124 gateway from the carton.
Check that there is no equipment damage.
Check, retain and process any documents.
Notify AudioCodes or your local supplier of any damage or discrepancies.
Retain any diskettes or CDs.
AC power cable.
2 short equal-length brackets and bracket-to-device screws for the 19-inch rack installation.
A CD with software and documentation may be included.
This MediaPack Fast Track Installation Guide.
2.2.4 on page 15 for cabling the MP-124.

Figure 2-9: Desktop or Shelf Mounting

2.2.1 below).
2.2.2 below).
2.2.3 on page 13).
2.2.4 on page 15).
13
2. Installing the MediaPack
October 2006