Advertisement
PRODUCT SAFETY & DISCLAIMER
READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE
PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY
•
This installation guide is provided as a GENERAL installation guide, some vehicles vary and
may require additional steps. We do not accept responsibility for third party labor charges
or modifications. Exercise due-diligence when installing this product.
•
We do not accept any responsibility for vehicle damage or personal injury resulting from
the installation of this product.
Careless installation and operation can result in equipment damage
•
Requirements:
Radio with cd changer controls
Introduction
Many Volvo owners looking to stream music via Bluetooth without changing the
look and feel of dashboard components will be pleased to find the A2D-VOL. This
adapter features Bluetooth music streaming for any Smartphone, Tablet,
Kindle, Laptop etc. with A2DP profile. The adapter connects radio 8-pin CD
changer port which guarantees the best quality sound on the car speakers.
Keep the radio and car you love while enjoying Bluetooth features only
available on newer cars.
Note: The A2D-VOL replaces external CD changer (if present).
For more see Frequent Asked question at the end of this guide.
Installation
Radio removal required to install module. (Applies to Volvo "SC", "CT" "CR"
changer controlling radios)
Warning: Although not critical, we recommend disconnecting battery. Keep in
mind, most Volvo radios are coded and will not operate without code. Radio
code must be available for radio to operate upon reconnection
1.
.
1.
2. Connect module 8-pin plug (See Fig. 3) to radio 8-pin "CD" port (See.
To remove push in on release tabs at bottom left & right of radio as
seen in Fig. 1
Fig. 1
Pull on both ring tabs as seen in Fig. 2
Fig. 2
Factory CD changer (if present) must be disconnected.
Fig. 4).
Fig. 3
Advertisement
