Advertisement
Fig. 4
8-pin "CD" port
Tap installation harness yellow wire (Battery) to one of two
10.
GREEN/BROWN
wires on "SC" radio harness (See Fig. 5)
Other radios (e.g. 'CR") use
GREEN/RED
(see how to use T-Tap on page 7),
Radio harness
11. Tap installation harness red wire (Accessory) to Yellow/purple wire on
"SC" radio harness (See Fig. 5)
12. Proceed to next section.
@ pin 9
Fig. 5
Pairing
Pairing varies among devices but basic steps are the same. This process is done
upon initial install and will not have to be repeated.
1.
Turn Ignition and radio "ON"
LED inside peephole will flash (pairing mode)
Settings, Wireless & Networks, Bluetooth
2. On A2DP device: go to
Settings
Bluetooth
3. Select
and turn on, select Bluetooth settings
Scan for devices
4. Tap
.
5. Wait for Bluetooth device name (See below) to appear and select it.
Once paired, LED inside peephole remains steady and confirmation tone
is heard on car speakers
Multi-device pairing
The A2D-VOL connects to one device at a time. You must disconnect first device
before pairing a second, or simply disable Bluetooth on first device.
Advertisement
