Advertisement
Operation
1.
Turn ignition and radio "ON"
2. Enter radio code if required.
3. Press CD, CH6 or CHGR button on radio.
Note: If radio does not switch to CD changer mode, check fuse or
voltage on yellow wire – See FAQ #6.
4. Launch Smartphone or tablet Audio streaming application
5.
Use radio volume control button to set playback level.
6. Make certain audio device volume is set to 80% or more. Turn volume
on radio to a comfortable listening level. If distorted, lower volume on
device until playback is distortion free.
7. If correct operation is confirmed go ahead and reinstall radio.
Warning: Playlist, Track selection, display name/number are *NOT*
possible from radio. Use audio device built-in controls or optional
wireless remote to access and control audio files and applications.
Frequent ask question
1.
What's the difference between A2D-VOL and A2DIY-VOL?
The A2DIY-VOL supports music streaming, Hands-Free calls
2. Does the A2D-VOL work on all Volvo radios?
NO;
works on select Volvo "SC", "CT" and "CR" changer controlling radios.
3. Is there a Bluetooth adapter for radios without changer controls?
YES;
Purchase our
ISFM23
or ISFM2351.
4. Can I control smartphone from radio buttons?
NO;
use smartphone built-in controls and display to operate device. Or
optional
wireless
remote. Use radio volume button to set the playback level.
5. Can I pair or save more than one device to the A2D-VOL?
YES;
more than one device (slaves) can be paired however only one
connection can be active at a time. To pair a second device, you must
disconnect first device.
6. My radio does not enter CD changer mode. What can I do to fix this?
Check fuse on yellow wire. If fuse is good, check voltage at the fuse. If
voltage is missing, ensure yellow wire is properly crimped to vehicles
battery supply (Go to step 10 of this installation guide. If both wires are
supplying power to modules and radio still does not enter "Changer' mode,
either the radio has not been programmed to support a CD changer or
module is defective, however to reduce that possibility, each module is
individually tested on our SC-816 radio prior to shipping.
7. With engine running there is a high pitch squeal that increases with
engine speed. What can be done to remedy this?
If you experience alternator whine (increases with engine speed), we
recommend installing a noise filter (e.g. NF3A) or similar.
Here is how to install our Noise Filter:
Filter connects to red accessory wire.:
- Connect module red wire to filter (out) red wire
- Connect filter (in) red wire to car accessory supply wire
- Connect filter black wire to ground
Advertisement
