For 1997-06 xk x100 and 1998-03 xj x308 with cd changer (11 pages)
Summary of Contents for Discount Car Stereo A2DIY-CR12
Page 1
Courtesy of: DiscountCarStereo.com Serving the internet community since 1995 A2DIY-CR12 QUICK START BLUETOOTH INSTALLATION GUIDE FOR PORSCHE CR-1 AND CR-2 RADIOS...
Smartphone: volume, track up/down/pause and more and can be mounted to steering wheel or dashboard. In addition, an optional “Smart charger’ kit helps to keep devices charged while on the road. Thanks to the A2DIY-CR12 kit, Porsche owners can update to Bluetooth®...
Page 3
2. Connect supplied 3.5mm audio cable (See Fig. 3) to module “AUX” jack 6. Porsche CR-1 and CR-2 radios have two possible wiring configuarions that varies based on vehicle (See Fig. 7). The A2DIY-CR12 module ships (See Fig. 4). Route audio cable other end to dash area or wherever Aux with power harness seen in Fig.
Page 4
Applies to vehicles with CD changer CD changer must be in working order. If for some reason CD malfunctions, the A2DIY-CR12 will not work. Radio removal required to gain access to connectors. Remove trim ring and ensure the 2 tabs are centered at which point the radio is pulled out the dash (grasping the cassette opening provides some leverage) or push from rear.
Fig. 15 Fig. 12 Flush mounted Flush mount 3 ft. USB cable 4. Tuck and secure any extra wire from moving parts and test operation Bracket Mount (No drilling) Locate a flat surface at location of choice within 3.2 ft. of module and mount USB support bracket (See Fig.
Page 6
3. Snap USB head (See Fig. 17) to bracket until flush (See Fig. 18) Bluetooth media button Pairing: Ensure Bluetooth is enabled on your device (e.g., Smartphone/Tablet etc.) Press and hold pause/play until Blue LED begin flashing Scan smartphone for available devices and select BT009 from list. (Blue LED turns off).
Operation: Pairing module Once paired with smart device (e.g., Phone, Tablet, etc.), users may perform the Pairing varies among devices but basic steps are the same. This process is done following functions on iOS with Bluetooth 3.0 and later or Android 4.0 or later. upon initial install and will not have to be repeated.