Advertisement
Flush to Dash or Panel
A.
Drill a ¾" hole in the dash or panel using a step drill bit or equivalent
1.
(See Fig. 10)
Fig. 10
Step drill bit
Insert supplied 3ft. USB male terminal (See Fig. 11) through hole
2.
created in step 1 and connect to module USB port (See Fig. 12)
Fig. 11
Flush mount 3 ft. USB cable
Fig. 12
USB port
(drilling required)
Snap USB head (See Fig. 13) in place and flush with mounting surface
3.
(See Fig. 14)
Fig. 13
USB head
Fig. 14
Flush mounted to dash
Tuck and secure any extra wire from moving parts and test operation
4.
Bracket Mount
B.
(No drilling)
Locate a flat surface at location of choice within 3.2 ft. of module and
1.
mount USB support bracket (See Fig. 15) to surface using
adhesive/tape or screws (included).
Advertisement
