Discount Car Stereo A2DIY-GM3 Quick Start Installation Manual

Bluetooth for select 2000-07gm class -ii radios

Advertisement

Quick Links

Courtesy of: DiscountCarStereo.com
Serving the internet community since 1995
A2DIY-GM3
QUICK START BLUETOOTH INSTALLATION GUIDE FOR SELECT 2000-07 GM CLASS -II RADIOS
C reated: D ecem ber 19, 2019
R evised: N ovem ber 11, 2020

Advertisement

Table of Contents
loading

Summary of Contents for Discount Car Stereo A2DIY-GM3

  • Page 1 Courtesy of: DiscountCarStereo.com Serving the internet community since 1995 A2DIY-GM3 QUICK START BLUETOOTH INSTALLATION GUIDE FOR SELECT 2000-07 GM CLASS -II RADIOS C reated: D ecem ber 19, 2019 R evised: N ovem ber 11, 2020...
  • Page 2: Installation

    A smart remote and push button are standard, but users may add an optional USB “Fast charge” kit to keep power hungry devices charged while on the road. Thanks to the A2DIY-GM3 users keep the factory radio while enjoying Bluetooth features only available on newer cars.
  • Page 3 5. Connect installation harness 22-pin Molex plug (See Fig. 2) to module 22- pin Molex connector (See Fig. 3) Fig. 5 push button Fig. 3 8. Use clip to install microphone to visor or headliner and route cable down pillar, under dashboard toward module location and connect to module 6.
  • Page 4 Optional push button with built-in microphone: Always use voltmeter to verify voltage and check for engine noise prior to finalizing. This option replaces standard visor microphone and separate push button Accessory power is active when ignition is in “ACC” or “ON “positions. shown in Fig.
  • Page 5: Bracket Mount

    Fig. 14 Fig. 11 Flush mounted to dash Flush mount 3 ft. USB cable Connect YELLOW wire to 12V battery or Accessory supply (your choice). When connected to battery supply, charging is possible at all times. When connected to Accessor supply, charging is possible only when key is set to ACC or ON positions.
  • Page 6: Smart Remote

    Fig. 16 Snap USB cable head (See Fig. 16) to bracket until flush (See Fig. 17) Installing smart remote: Install wireless remote to dashboard or panel with provided holder or double side tape. Remote control operation: Once paired to your smartphone, perform the following functions on iOS7.0 and Fig.
  • Page 7: Test Operation

    Push button works both Android and Apple devices: Test Operation: To answer/end call; press push button once To switch between streaming and AUX; press push button once. Turn ignition and radio “ON” Press push button twice in quick succession to redial last number. 2.
  • Page 8: Frequently Asked Questions

    © 1995-Nov-20 Discount Car Stereo, Inc. All rights reserved. Information in this document is subject to change without notice. Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark holders.

Table of Contents