Troubleshooting - Fujitsu PRIMERGY LTO4 User Manual

7

Troubleshooting

This chapter explains the actions to be taken for each LED error display by this
product and the actions to be taken when this product does not operate normally.
Troubleshooting for LED display
The following table indicates the status of LED display. As for error status, the troubleshooting
method is described. If the problem is not resolved after performing the following troubleshooting,
contact an office listed in "Appendix C Contact Information" ( p.100).
LED Display
Two-color: Off
Segment: Off
One-color: Off
Two-color: On (green)
Segment: –
One-color: Off
Two-color: On (green)
Segment: Off
One-color: Off
Two-color: Blinking (green)
Segment: Off
One-color: Off
Two-color: Blinking (green)
Segment: C
One-color: Blinking
Two-color: On (green)
Segment: P
One-color: Off
Two-color: Blinking (amber)
Segment: F
One-color: Blinking
Status and Action
Status PowerOff: Power is not supplied.
Action The LED is in this status even if the server power
was turned on, check that the server and this product
are connected properly.
Status PowerOn (No cartridge): Power is supplied and a
data cartridge is not inserted.
When a cartridge is inserted, the LED turns into
"Ready" status.
Status Ready: Power is supplied and a data cartridge is
inserted. This product can be used.
Status Running: This product is loading/unloading,
unwinding the data cartridge, or writing/reading
data on the data cartridge.
When the data cartridge is inserted and running, this
product is in normal status.
Action If the LED is in this status when the data cartridge is
not inserted, a failure may occur.
Status Cleaning: Wait for head cleaning to be finished, and
the data cartridge to be automatically ejected.
Status The write-protect cartridge or LTO2 (Read Only)
cartridge was loaded.
Use as is when not writing data. When writing data,
release write protection or replace the data cartridge
in order to use the data cartridge.
Status Updating the firmware: Wait for the firmware to be
updated and the LED display to become "PowerOn
(No cartridge)" or "Ready".
E
85
7 Troubleshooting