Fujitsu PRIMERGY LTO4 User Manual page 99

3
Press [F2] key.
If [F6] key was pressed at the Step 2, reading the driver is executed.
1. Insert the driver floppy disk that was created at Step 1 in " Prearrangement"
( p.98)
.
2. Press the [S] key as many times as necessary and read driver information.
3. When reading all the drivers has completed, press the [Enter] key.
Reading task finishes.
4
Subsequently, insert the driver floppy disk, the ASR floppy disk,
etc. in accordance with the displayed messages.
・ When the message "Cannot copy a file nnn (nnn indicates a file name)" appears, insert the
driver floppy disk that was created at Step 2 in " Prearrangement" ( p.98) to read a target
file.
・ If "The file 'QLTOnnn.sys' on Quantum LTO Tape Driver for Windows 2000/XP/2003/
Vista is needed. Type the path where the file is located, and then click OK." is displayed,
specify "c:\temp" in the copy source folder and click "OK".
・ When the dll file of the tape device is asked, insert the ASR floppy disk that contains the
target file to be read.
5
When the "Start Automated System Recovery Wizard" screen
appears, insert a ASR backup data data-cartridge.
The recovery task starts.
6
When the recovery task has completed, restart the system.
When the system has recovered normally, the procedures are done.
Appendix B Automated System Recovery (ASR)
E
99