Preventative Maintenance - U-Line H-9379 Manual

CONSIDERATIONS WHEN USING PROPULSION
• Always operate hand truck only as fast as safety
considerations allow.
• When turning tight corners, keep unit close to the
turn in the direction of travel. When turning right,
keep unit close to the turn on the right. When turning
left, keep unit close to the turn on the left.
• Use extra caution when moving loads on ramps or
moving loads in reverse
• While unattended, turn off unit.
• Do not drive hand truck through more than 2" of
water, and never submerge drive system or battery
box.
• Do not drive off curbs or ledges higher than one
inch. An aluminum walk ramp must be used to
overcome obstacles over one inch.
GENERAL MACHINE CARE
• Charge machine in a dry place, preferably at 50ºF
or warmer.
• Wash machine with warm, soapy water. Do not use
pressure washers.

PREVENTATIVE MAINTENANCE

AREA
Drive Wheels
Fasteners
Battery
Charging
Casters
Transaxle
PAGE 7 OF 25
OPERATION CONTINUED
MAINTENANCE
INSPECTION FREQUENCY
Daily
Daily
Daily
Daily
Daily
AFTER USE
1. Ensure hand truck is unloaded.
2. While unattended, turn unit off.
3. When batteries are installed, unit should be stored
and charged indoors and in a dry environment. To
maximize battery life and minimize charge time,
temperatures should be between 50º-100ºF.
4. Charge batteries as soon as possible upon returning
with unit from use. Charge daily or after every use in
a dry, well-ventilated area away from sparks, heat
and flames. Do not use an extension cord if possible.
Do not use charger if the cord is damaged.
• Do not drive through more than 2" of water, and
never submerge drive system or battery box.
• Drive system is lubricated for life, so no maintenance
is required for drive system.
• Keep pneumatic tires inflated to 20-25 psi.
PROCEDURE/NORMAL CONDITION.
Inspect wheels and tires for wear and
cracks.
Keep pneumatic tires inflated to 20-25 psi.
Tighten any loose hardware.
Orange or green charging light should turn
on when charging.
Inspect for wear; clean dirt and debris.
Transaxle should be kept free and clear of
debris.
When stored, transaxle lever should be kept
in powered mode with power off to keep
unit from rolling freely.
0321 IH-9379