Advertisement
MAINTENANCE AND CHARGE OF BATTERY
1. A Various Rechargeable Sealed Lead Acid battery
(VRLA) is used in this pallet truck.
2. The H-2302 pallet trucks are equipped with a
specific charger to charge the battery. The charger
can be plugged into a standard 120 volt outlet.
CAUTION! Before connecting the charger to
the battery, make sure the battery charger
emergency shut-off switch and key switch are
in the off position. Please charge the battery
in a dry, well-ventilated area and keep away
from any source of fire. If the truck is not in use,
battery charges should be performed no less
than once per month.
3. The battery of the pallet truck should be charged
fully and regularly. When "Capacity Insufficient"
alarm flashes on Battery Capacity Meter during
operation, please charge the battery immediately.
4. The charger will adjust the current according to
residual capacity of the battery automatically,
which ensures the battery is charged correctly.
After charging the battery, the charger indicator
lights turn green and charger stops automatically.
Battery charging generally takes 5-7 hours.
BATTERY INDICATOR
5. BATTERY CAPACITY METER – The charge status of
battery is indicated on Battery Capacity Meter with
ten indicator bars for each 10% increase. With the
consumption of battery capacity, the lighting bars
will descend downwards from the top. (See Figure 5)
6. The truck will automatically cut off lifting functions
when the battery reaches 20%.
Figure 5
Capacity Sufficient
Charge Required
0
1
PREPARATION OF TRUCK TO BE REPAIRED OR
MAINTAINED
Prepare all necessary safety measures to avoid a
possible accident during the course of repair and
maintenance by taking the following precautions:
PAGE 4 OF 7
Capacity Insufficient
0
1
0
MAINTENANCE
1.
Park the truck safely.
2. Press emergency shut-off switch and disconnect
the battery.
INSPECT HYDRAULIC OIL CAPACITY
1.
Remove the four screws (1) and (2). (See Figure 5)
2. Open the left and right half cover (3) and (4).
3. Check the capacity of hydraulic oil in oil tank.
NOTE: During Inspect hydraulic oil capacity,
forks and carriage must be lowered to the
minimum height.
INSPECT ELECTRIC FUSE
1.
Remove the four screws (1) and (2). (See Figure 5)
2. Open the left and right half cover (3) and (4).
3. Consult the chart to check the current rating of all
fuses and replace if necessary.
CODE
FU
FU1
FU2
USE OF TRUCK AFTER MAINTENANCE
Finish the following operation before use of truck:
1. Clean the truck.
2. Check the brakes.
3. Check the Emergency Shut-Off Switch.
4. Check the horn.
Figure 6
1
PROTECTION PURPOSE
Main Circuit Fuse
Traveling Control Fuse
Lifting Control Fuse
1
4
3
CURRENT
RATING
200A
10A
6A
2
0321 IH-2302
Advertisement
