General Information; Units Of Measurement; Replacement Parts; Machine Identification - MASSEY FERGUSON 9070 Workshop Service Manual

GENERAL INFORMATION

UNITS OF MEASUREMENT

Measurements are given in metric units followed by the
equivalent in U.S. units. Hardware sizes are given in
millimetres for metric hardware and inches for U.S.
hardware.

REPLACEMENT PARTS

To receive efficient service, always give the dealer the
following information:
• Correct part description or part number.
• Model number of the machine.
• Serial number of the machine.

MACHINE IDENTIFICATION

FIG. 1: Each machine is identified by a model and serial
number on the serial number plate (1). The serial number
plate is located on the left-hand end of the header.
NOTE: Always give the model number and serial number
in any communication to your Dealer.
2-2
FIG. 1
1
LA27102
4283063M1