Sony Giga Juke NAS-50HDE Operating Instructions Manual page 96

Notes
 Backing up may take a long time (up to 60 to 80 of
hours) depending on the amount of data, the USB
hard disk, the computer, and the network status.
 Backed-up audio data cannot be copied to or used
on devices (such as a computer) other than this
unit.
 If FAT32 formatting has been done on the USB
hard disk by another device such as a computer,
the audio data will be backed up in the first
partition of the USB hard disk. Backing up
of audio data will not be possible if sufficient
space is not available in the first partition. If you
need more space, repartition the hard disk on a
computer, etc. to provide enough space for backing
up.
 If the USB hard disk is not formatted, perform
FAT32 formatting of the first partition on this unit
(page 97) before proceeding with the backing up
operation.
 Backing up of only new material may not be
carried out correctly if the clock is not set
correctly.
To back up data to the USB hard
disk
You can back up data from the HDD of the
unit to a USB hard disk (optional).
1
Use a USB cable to connect the hard disk to
the USB connecting jack of the unit.
Notes
 If two USB hard disk devices are connected to
both USB connecting jacks (front and rear) at
the same time, the device connected to the front
jack takes priority.
 If you want to use the USB hard disk that is
connected to the USB connecting jack on the
rear of the unit, disconnect the USB hard disk
that is connected to the front jack.

GB
Front or rear of the main unit
To the USB
connecting jack
Hard disk drive (optional)
 The shape of the USB connector will differ
according to the USB hard disk being used.
 Refer to the customer support site of Sony
Europe, http://support.sony-europe.com/ (for
the customers in Europe only) for supported
USB hard disks. If a USB hard disk that is not
supported is connected to this unit, it may cause
the unit to malfunction.
2
Enter the Setup menu and select [Backup].
The back up setting window appears.
3
Select [Backup data].
The destination drive selection display
appears.
4
Select [USB hard disk].
A confirmation window for the selected drive
appears.
5
Confirm the displayed item and select [Yes].
Backing up starts.
When the back up ends, "Backup completed
normally. " appears in the display.
To the USB
connecting jack
USB cable (optional)