Sony Giga Juke NAS-50HDE Operating Instructions Manual page 93

To check the network status
1
Select [Network status check] in the wired
LAN setup display.
2
Select [Execute].
The unit starts checking the network status.
When the unit finishes checking, [OK] or [NG]
appears for each item. It may take for a few
minutes until the unit finishes checking.
• If [OK] appears for all items, go to step 5.
• If an [NG] appears, go to step 3.
3
Select [Details] for items marked by an [NG].
The display shows the assumed cause of the
problem.
4
After reading the cause in step 3, follow the
instructions that appear in the display to
make the settings again, and then repeat
steps 2 and 3 until the [NG] changes to [OK].
In certain network environments, such as an
office LAN, [NG] may appear even though all
connections and settings are correctly made. In
this case, contact the network administrator.
5
Select [Close].
The display returns to the network setting display.
6
Select [Close] or press BACK.
The network setting display closes.
To set up a USB wireless LAN
network
1
Enter the Setup menu and select [Network].
2
Select [LAN] – [Wireless].
3
Select [Wireless LAN setting].
4
Select [Access point setting] – [Search for
available access point.].
Select the access point from the search
results.
5
Set the SSID, security setting and network
key, and then select [Save].
6
Select [Close]
The display returns to the wireless LAN
access point setting display.
7
Select [Close].
The display returns to the wireless LAN
setting display.
After this procedure, do the IP address and
proxy server settings (shown below).
Tip
You can manually set the access point in step 4.
To set the IP address and proxy server
After you set the access point, you have to do the IP
address and proxy server settings. Do the procedure
from step 4 of "To set up a wired LAN network"
(page 92) to make these settings (only the necessary
items for the wireless LAN setting appear). If
these settings are made automatically, confirm the
contents and select [Apply].
Note
If you have disconnected the USB adaptor after
setting these items, enter the Setup menu again,
select [Network] – [Wireless LAN setting]
– [Address setting], and then select [Apply].

GB