CONTENTS | SPECial iNfOrmaTiON
SPECIAL INFORMATION
OPERATION
1.
1.1
1.2
1.3
1.4
1.5
2.
Safety ����������������������������������������������������������4
2.1
2.2
2.3
3.
4.
5.
Settings �������������������������������������������������������5
6.
7.
8.
Safety ����������������������������������������������������������6
8.1
8.2
9.
9.1
9.2
10.
Preparation ���������������������������������������������������6
10.1
10.2
11.
Installation ����������������������������������������������������7
11.1
11.2
11.3
11.4
11.5
11.6
12.
12.1
12.2
12.3
13.
13.1
13.2
13.3
14.
15.
Maintenance ������������������������������������������������ 15
16.
Specification ������������������������������������������������ 16
16.1
16.2
16.3
16.4
16.5
GUARANTEE
ENVIRONMENT AND RECYCLING
2
| HSBB 180 Plus (GB)|HSBB 180 S Plus (GB)
SPECial iNfOrmaTiON
- The appliance may be used by children over
8 years of age and persons with reduced phys-
ical, sensory or mental capabilities or a lack of
experience and expertise, provided that they are
supervised or they have been instructed on how
to use the appliance safely and have understood
the potential risks. Children must never play with
the appliance. Cleaning and user maintenance
must not be carried out by children without
supervision.
- The connection to the power supply must be in
the form of a permanent connection. Ensure the
appliance can be separated from the power sup-
ply by an isolator that disconnects all poles with
at least 3 mm contact separation.
- Observe all applicable national and regional reg-
ulations and instructions.
- Observe minimum distances (see chapter "Instal-
lation / Preparations / Installation site").
- Only a qualified contractor should carry out in-
stallation, commissioning, maintenance and re-
pair of the appliance.
DHW cylinder
- Drain the appliance as described in chapter
"Installation / Maintenance / Draining the DHW
cylinder".
- Observe the maximum permissible pressure (see
chapter "Installation / Specification / Data table").
- The DHW cylinder is under supply pressure. If no
diaphragm expansion vessel is installed, expan-
sion water will drip from the safety valve during
heat-up.
- Regularly activate the safety valve to prevent
it from becoming blocked, e.g. by limescale
deposits.
- The safety valve drain aperture must remain open
to atmosphere.
www.stiebel-eltron.com