Tape - Recording; Recording A Cd On A Tape; Cd-Tape Synchro Recording; Recording An Md On A Tape - Sony CMT-CP500MD Operating Instructions Manual

Tape — Recording

Recording a CD on a tape

— CD-TAPE Synchro Recording

You can use Type I (normal) tape.
1
Load a recordable tape.
2
Load a CD.
3
Press SYNCHRO REC repeatedly until
"CD-TAPE SYNC" appears in the
display.
4
Press ENTER/START.
The tape deck stands by for recording and
the CD player pauses for play.
When you want to record on the reverse
side, press TAPE nN so that "n"
appears in the display.
5
Press PLAY MODE DIRECTION
repeatedly until
one side or
both sides.
6
Verify that "Press START" flashes in
the display. Then press ENTER/START.
Recording starts.
To stop recording
Press CD x or TAPE x.
Tips
• When you record on both sides, be sure to start
from the front side. If you start from the reverse
side, recording stops at the end of the reverse side.
• If you select both sides recording and the tape
reaches the end of the front side part-way through a
track, the entire track is recorded again from the
beginning of the reverse side.
• You can record only your favorite CD tracks with
CD Program Play. After step 2, follow the same
procedures as from step 1 to 5 in CD Program Play
(see page 10). Then go to step 3.
GB
38
appears to record on
(or ) to record on
Recording a CD on an MD and
a tape at the same time
Load the CD you want to record. Then load a
recordable tape and MD. Press SYNCHRO
REC repeatedly until "DUAL SYNC" appears
and then perform step 4 through 6 of
"Recording a CD on a tape".
To stop recording
Press CD x, MD x or TAPE x.
Tips
• Even if the MD or the tape ends part-way through
the recording, the other continues recording.
• If you select both sides recording and the tape
reaches the end of the front side part-way through a
track, the entire track is recorded again from the
beginning of the reverse side. In this case, the entire
track may also be recorded again on the MD.
• You can record only your favorite CD tracks with
CD Program Play. After step 2, follow the same
procedures as from step 1 to 5 in CD Program Play
(see page 10). Then go to step 3.
Recording an MD on a
tape

— MD-TAPE Synchro Recording

You can use Type I (normal) tape.
1
Load a recordable tape.
2
Load an MD.
3
Press SYNCHRO REC repeatedly until
"MD-TAPE SYNC" appears in the
display.