Table of Contents
Advertisement
If memory card is not present or if No was selected, the following message is displayed:
Disconnect HP/LP tubes from the system.
Disconnect the device from the vehicle A/C system.
Open LP and HP valves.
Confirm with Enter.
Warning! Refrigerant recovery from tubes
This message confirms refrigerant recovery from tubes.
Close LP and HP valves
Follow the instructions and press Enter. The device will show the message about going into
stand-by mode.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Clima-Tech Plus and is the answer not in the manual?
Questions and answers
Problème étalonnage code erreur ne peut plus étalonné
Calibration performed by an unauthorized service station is considered an issue with the Magneti Marelli Clima-Tech Plus. This is not covered under the warranty and may result in additional costs for the client.
This answer is automatically generated
Boa tarde, Gostaria de reseta sem o tempo de manutenção teria como fazer isso
To reset the maintenance timer on a Magneti Marelli Clima-Tech Plus:
1. Navigate to the vacuum pump counter reset menu.
2. Press ENTER to confirm.
3. When the display shows "Hold ENTER button for 3 seconds! Counter reset," hold the ENTER button for 3 seconds.
4. Confirm the reset by pressing ENTER again.
This completes the maintenance timer reset.
This answer is automatically generated