Table of Contents
Advertisement
Open LP and HP valves on control panel or one of the valves, depending on the A/C
system type.
Recycling phase
This message appears on the display for a few seconds.
Recycling in process – qty of recovered
refrigerant g
Recovery phase stops automatically when the station detects that the system was
emptied. System leak test is then started.
Min. pressure
growth control
Oil recovery
in process
The station will remove used oil to the used oil tank. (21).
Please wait!
Recycling finished!
g
XXXXX
Recovery phase is finished.
Vacuum generation!
Time
XX:XX
When the planned vacuum generation time is elapsed, the station starts system leak test.
Leaktightness check
s
XXX
mBar XXX
Data is presented on the display for a few seconds.
Vacuum finished!
mBar
XXX
9 RUNNING PROGRAMMED PHASES
9.1 Recovery phase
XXXXX
9.2
Vacuum phase
If increased pressure is detected,
recovery phase is repeated.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Clima-Tech Plus and is the answer not in the manual?
Questions and answers
Problème étalonnage code erreur ne peut plus étalonné
Calibration performed by an unauthorized service station is considered an issue with the Magneti Marelli Clima-Tech Plus. This is not covered under the warranty and may result in additional costs for the client.
This answer is automatically generated
Boa tarde, Gostaria de reseta sem o tempo de manutenção teria como fazer isso
To reset the maintenance timer on a Magneti Marelli Clima-Tech Plus:
1. Navigate to the vacuum pump counter reset menu.
2. Press ENTER to confirm.
3. When the display shows "Hold ENTER button for 3 seconds! Counter reset," hold the ENTER button for 3 seconds.
4. Confirm the reset by pressing ENTER again.
This completes the maintenance timer reset.
This answer is automatically generated