Data Transfer - Kolida K3 IMU User Manual

K3 IMU
§3.4.5 Data Transfer
This performance contains General, Serial Port Config, TCP/IP Config, NTRIP Config and Data
Flow Config. The "Data Transfer" allows to configure the output mode for raw observation data
and differential data, as well as to the NTRIP performance configuration.
General
This page shows the service condition and the output contents of the ports, if the port item display in
green, that means the port is being used, and the port is not used while the item display in red.
Serial port Config
This page is allowed to configure the baud rate, odd-even check and the data flow for serial port
(5-pin port) and Bluetooth.
CAUTION: do not change the default value in this page for each item, if you want to
change the settings, please contact with KOLIDA technician for further support.
In the dropdown list of data flow, there shows 4 items for selection.
Raw observation data: This is the raw observation data straight from OEM board.
Correction Data: This is the correction data straight from OEM board.
Navigation Data: This is the navigation data output from receiver such as NMEA-0183, GSV,
- 24 -