Attaching The Embroidery Frame - Brother 885-V35 Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
EMBROIDERY

Attaching the Embroidery Frame

This section describes how to attach the embroidery frame.

Attaching the embroidery frame

a
Wind the embroidery bobbin thread onto the
bobbin and set it into the bobbin case.
• For details, refer to "Winding/Installing the
Bobbin" (page 22).
b Raise the presser foot lever.
a Presser foot lever
c Press (Needle position button) once or
twice to raise the needle.
a Needle position button
d Pass the embroidery frame under the presser
foot while raising the presser foot lever even
further.
CAUTION
● Do not touch the start/stop button,
needle position button or reverse/
reinforcement stitch button. If one of the
buttons is accidentally pressed, the
machine will begin sewing and your
finger may be pricked with the needle or
the needle may break.
148
a
a
e Firmly insert the embroidery frame guide into
the embroidery carriage frame holder from the
top.
Line up the embroidery frame guide tabs and
the embroidery carriage frame holder slots and
push in until it clicks and stops.
b
a Embroidery frame guide tabs
b Embroidery carriage frame holder slots
The embroidery unit is attached.
Note
Be sure to insert both pins. If only the
forward or the back pin is inserted, the
pattern may not turn out correctly.
CAUTION
● Correctly set the embroidery frame into
the embroidery frame holder. Otherwise,
the presser foot may hit the embroidery
frame, resulting in injury.
a