Remote Commands - Brother FAX-4100 Owner's Manual

Remote Commands

Follow the commands below to access features remotely. When you call your
machine and enter your Remote Retrieval Access Code (1 5 9
will signal you with two short beeps to enter a remote command.
Remote Commands
95 Changing Fax
Forwarding
/Paging setting
1 OFF
2 Fax Forwarding
3 Paging
4 FAX FWD No.
6 Fax Storage ON
7 Fax Storage OFF
96 Retrieve a fax
2 Retrieve all faxes
3 Erase fax from the
memory
97 Check the Receiving
Status
1 Fax
98 Change Receive Mode
1 TAD
2 FAX/TEL
3 FAX
90 Exit
Operation Details
If you hear one long beep, the change is accepted. If you
hear three short beeps, you cannot change it because the
conditions have not been met. (Example: registering
paging number). You can register your fax forwarding
number by using 4. FAX FWD NO (See Page 9-6). Once
you have registered the number, your machine will
change automatically to FAX FWD:ON mode.
You can set FAX STORAGE to ON or OFF.
Enter the number of a remote fax machine to receive
stored fax message(s). (See Page 9-6.)
If you hear one long beep, you can erase fax message(s)
from the memory.
You can check whether your machine has received any
fax message(s). If yes, you will hear one long beep. If no,
you will hear three short beeps.
If you hear one long beep, you can change the Answer
Mode.
If you hear three short beeps, you cannot change it.
After a long beep, you can exit remote retrieval.
R E M O T E F A X O P T I O N S
), the system
9 - 5