CONTENTS SAFETY INSTRUCTIONS OPERATING GUIDELINES Warning for the machine Warning for docking station Warning for batery USING APP EUREKA ROBOT APP QUICK GUIDE TECHNICAL DATA DAILY MAINTENANCE AND SERVICING PRODUCT INTRODUCTION Dustbin maintenance Water tank maintenance Open-box accessories layout Cleaning tools...
SAFETY INSTRUCTIONS SAFETY INSTRUCTIONS WARNING FOR THE MACHINE This appliance can be used by children aged from 8 Do not bring the smart robot close to heat source, years and above and persons with reduced physical, radiation or burning cigarette butts. It is strictly sensory or mental capabilities or lack of experience forbidden to vacuum the following objects: and knowledge if they have been given supervision...
Page 4
SAFETY INSTRUCTIONS SAFETY INSTRUCTIONS - Incorrect use, e.g. overloading of the appliance, use of non-approved accessories - Use of force, damage caused by external influences - Damage caused by non-observance of the user Correct Disposal of this product. manual, e.g. connection to an unsuitable mains This marking indicates that this product should not supply or non-compliance with the installation be disposed with other household wastes through-...
Observe the plus (+) and minus (–) marks on the cell, Docking station is only applicable to the product battery and equipment and ensure correct use. NER600. Do not use any cell or battery which is not designed for use with the equipment.
Page 6
SAFETY INSTRUCTIONS SAFETY INSTRUCTIONS Keep cells and batteries out of the reach of children. Always purchase the correct cell or battery for the Seek medical advice immediately if a cell or a battery equipment. has been swallowed. Keep cells and batteries clean and dry. Wipe the cell or battery terminals with a clean dry cloth if they become dirty.
PRODUCT INTRODUCTION PRODUCT INTRODUCTION Open-box accessories layout Introduction of main-unit components Top view Startup&shutdown/ Layout start&pause key Navigation module Dustbin/water tank release key One charing Accessories box dock (power cord 、HEPA) Buttom view One main unit Charging chips for Side brush main unit Accessories box (Mop holder 、...
INSTALLATION Notes Do not place the charging dock in direct sunlight; Installation of charging dock Do not cover the signal emission area of the charging dock with stickers or other objects; Do not place the charging dock on soft floors such as the ones installed with carpet; The End A of the power cord is connected to the charging dock, while the End B is plugged in a power outlet.
INSTALLATION INSTALLATION Installation of mop assembly (this step can be skipped, please install when Installation of side brush needing to mop the floor) By ensuring the side brush has a When disassembly is required, use consistent color with that of its two hands to hold the rubber-cov- Press the water tank release key, Remove the rubber plug from the...
During the charging, the power indicator flashes, and then it is always on after completion of the charging. Add your robot vacuum to your app Press the " + " button on the main screen of the app and select NER600 from the available list of products.
Dustbin maintenance (weekly cleaning recommended) If the Wi-Fi in your home is unstable, it may cause a certain delay in the related operations of the Eureka Robot App. (The content of the Eureka Robot App is subject to the upgraded version of App. Please refer to the Eureka...
DAILY MAINTENANCE AND DAILY MAINTENANCE AND SERVICING SERVICING Water tank maintenance (weekly cleaning recommended) Cleaning tools Press the tank release key to remove From the tank body, slightly Cleaning tools are located above the Cleaning brushes are used for the the tank assembly;...
- Shut down the silence mode Machine shows no voice - Turn up the volume with Eureka App - Reconnect with cellar network - Restart the router - Turn on the power switch of the robot cleaner...
FAQs FAQs Fault description Treatment methods Fault description Treatment methods - Move the main unit out of the charging dock, Main unit cannot return - See the "Initial Use" section in the "Quick Start and long press the power key for about 3s, then to charge Guide"...
Page 16
FAQs Fault description Treatment methods - Turn over the main unit, check whether its Machine goes in circles wheels rotate freely, and in case of any foreign matters, clean them up immediately - Wash HEPA and dry it before use, avoid operating the machine in areas with water accumulation Loud noise...
Need help?
Do you have a question about the NER600 and is the answer not in the manual?
Questions and answers