Download Print this page

Operation; Brush Options - Aztec SIDEWINDER 24 Owner's Manual

Hide thumbs Also See for SIDEWINDER 24:

Advertisement

some gas until the cloud disappears and
escaping gas is "clear" . Reinstall tank.
All machines are equipped with tamper proof fuel
systems. If a fuel problem exists, contact an
authorized service center.
Propane tanks should be removed & stored in a
protected off site area.
No machine with a Dead Man Lever Clutch should
be left running disengaged. Upon starting,
engage clutch immediately to prevent belt from
burning. Burning of the belt causes premature
failure and is a misuse not covered by warranty.
SIDEWINDER STRIPPER
24" & 30" MODELS
The Aztec Sidewinder is designed to deep scrub and/or
strip hard surface floors in preparation for top coat or
restoring of tile, smooth concrete, terrazzo or close
fitted tile. Any other application of the equipment should
be checked with customer service at the factory to
determine if the proposed use is appropriate.
IV. OPERATION
A. Determine best brush or pad option for task.
B. Transport Sidewinder by tilting on rear wheels.
C. After applying cleaning or stripping solution, start
engine, engage clutch & initiate operation at a slow
to moderate walking speed.
D. When area is completed, disengage clutch
immediately, stop engine.
E. Clean equipment.
F. Remove propane tank & store off-site (outside).
Never tilt back machine while engine is running.
Never reach under protective shroud when engine
is running.
V. AFTER OPERATION CLEANING
A. Place Sidewinder in "tilt back" position.
B. Rinse unit between top of brushes and brush plate.
Do not spray water into brush drive (above plate).
C. Rinse around splash skirt and fiberglass body.
D. Start engine and run Sidewinder briefly to expel any
excess water.
E. Store propane tank in a secure, well ventilated off
site location.
SIDEWINDER BRUSH
AND PAD OPTIONS

BRUSH OPTIONS

GREY
The most aggressive stripping brush
when new. .070 dia. Strata-Grit Plus
(3 ROW)
bristles. Has 25% more silicon carbide
than any other bristle.
Lasts up to .75-1.25 million sq. ft.
SW 30" Part # 010-962STB
SW 24" Part # 01024-962STB
BROWN/RED
Very aggressive stripping brush. Holds
up best when doing concrete.
(4 ROW)
.080 dia. Malgrit-Xtra bristles last longer.
Lasts up to 1-1.5 million sq. ft.
SW 30" Part # 010-962STBH
SW 24" Part # 01024-962STBH
BLUE
Deep scrubbing and light stripping.
.060 dia. Strata-grit bristles.
(5 ROW)
Lasts up to 1-2 million sq. ft.
SW 30" Part # 010-962SCB
SW 24" Part # 01024-962SCB
BLACK NYLON Light shower scrub. Will not remove
finish. .020 dia. nylon bristles.
(5 ROW)
Lasts up to 1 million sq. ft.
SW 30" Part # 010-962SCBL
SW 24" Part # 01024-962SCBL
WIRE
For light scarifying or compacted
debris removal on concrete applications.
(5 ROW)
Lasts up to 15,000-25,000 sq. ft.
SW 30" Part # 010-962WB
SW 24" Part # 01024-962WB
PAD DRIVER
Designed for driving 10" pads. Pad
SYSTEM
Grabber III to hold pads. Quick connect
pad clips for easy pad change. Comes
with Black Hi-Pro pads. Nylon bristles
help to prevent pads from clogging.
SIDEWINDER PG. 2

Advertisement

loading

This manual is also suitable for:

Sidewinder 30