Identifying M40E Fpcs; Figure 6: M40E Fpc - Juniper M40E Hardware Manual

M40e Multiservice Edge Router Hardware Guide

Identifying M40e FPCs

16
All manuals and user guides at all-guides.com
EEPROM—Stores the serial number and revision level of the FPC.
Two LEDs—Indicate FPC status. The LED labeled
is red. The LEDs for each FPC are located on the router craft interface. For more
information, see "FPC LEDs and Controls on the M40e Craft Interface" on page 38.
Offline button—Prepares the FPC for removal from the router when pressed. Like the
LEDs, an offline button is located on the craft interface. For more information, see "FPC
LEDs and Controls on the M40e Craft Interface" on page 38.
Four PIC offline buttons (on Type 1 FPCs only)—Prepare each corresponding PIC for
removal from the FPC.
Ejector levers—Control the locking system that secures the FPC in the card cage.
NOTE: For specific information about FPC components (for example, the
amount of memory available), issue the
Figure 6 on page 16 shows the standard M40e FPC.

Figure 6: M40e FPC

Ejector le ver
Ejector le ver
Figure 7 on page 17 shows the Enhanced Plus FPC1 and Enhanced Plus FPC2 supported
by the M40e router.
is green and the one labeled
OK
command.
show chassis fpc
Copyright © 2010, Juniper Networks, Inc.
FAIL