Trouble Shooting; Section 6 Service, Trouble Shooting Table - Zip HydroTap G5 BCS Installation Instructions Manual

6.1 Service items
• Filters should be replaced at six month intervals for Commercial HydroTaps, and 12 month intervals for
Residential HydroTaps.
• CO2 regulator washers should be replaced annually.
6.2 Trouble shooting table
Fault
Fault name
code
000 Power Board Fault
001 Interface Fault
004 Water Leak, Isolate Mains
005 Compressor OverRun
006 Water Supply Failure
007 Hot Sensor Open
008 Hot Sensor Closed
009 Cold Sensor Open
010 Cold Sensor Closed
011 Flood Sensor Open
012 Condenser Sensor Closed
013 Condenser Sensor Open
014 Heater Fuse/Driver Fault
015 Heater Driver Fault
016 Compr Driver Fault
017 Hot Sensor Degraded
018 Condenser Overtemp
019 A DC Pump is faulty
020 Steam too cool
021 Steam Sensor Open
022 Steam Sensor Closed
023 Over Steamed
024 Hot Tank Overfilled
025 Comp Fuse/Driver Fault
027 Boil dry protection
• Call Zip for Advice and assistance (see contact details page 111).
806834 v1.02 07.21 G5 Online install instructions and user guide
Section 6 Service and Trouble shooting
Water detected in the unit due to tank overfill or
Compressor has been running continuously for an extended
Temperature of condenser has exceeded its limit
Heating protection device has activated
Fault trigger
Internal communication fault
Internal communication fault
internal / external leakage.
time period
Water not detected by unit
Internal sensor fault
Internal sensor fault
Internal sensor fault
Internal sensor fault
Internal sensor fault
Internal sensor fault
Internal sensor fault
Internal component fault
Internal component fault
Internal component fault
Internal sensor fault
Internal component fault
Boiling calibration error
Internal sensor fault
Internal sensor fault
Excess steam detected
Hot tank has over filled
Internal component fault
67