Table of Contents
Advertisement
Universal tray and wire rack with
non-tip safety notches
Universal tray HUBB 30-1:
Wire rack HBBR 30-2:
The wire rack has non-tip safety
notches fitted on the short sides. The
non-tip safety notches prevent the wire
rack from being pulled out completely
when you only wish to pull it out
partially.
Always slide the wire rack into the side
runners with the catches facing down,
ensuring that it is located on the
runners of a single shelf level.
Useful tip: When using the universal
tray, place it directly on the wire rack.
Fully telescopic rails with wire
rack HFCBBR 30-3
The fully telescopic rails with wire rack
are attached to the side runners and
can be pulled completely out of the
oven so that you can inspect the food
easily.
The fully telescopic rails with wire rack
are pushed onto the runners of a single
shelf level and then locked into place.
The fully telescopic rails can support a
maximum load of 15 kg.
You can use the fully telescopic rails
with wire rack on any shelf level.
Installing and removing the fully
telescopic rails with wire rack
Risk of injury due to hot surfaces
The oven gets hot during operation.
You could burn yourself on the
heater elements, oven compartment,
or accessories.
Allow the heater elements, oven
compartment, and the accessories to
cool down before installing or
removing the fully telescopic rails
with wire rack.
When installing or removing the fully
telescopic rails, do not extend them.
Features
27
Advertisement
Table of Contents
