Bj Mode Command Summary - Canon K10158 User Manual

BJ mode example
This part shows that the decimal form the command to specify
condensed text is 15 and the character form of the same command is SI.
To access condensed (17 cpi) text in Lotus 1-2-3 when you are in BJ
mode, follow this procedure.
Each number in the decimal form of the command must be three
characters long, so you need to use a leading zero if the code is a two-
digit number. A simple command might look like this:
\077
1.
In Lotus 1-2-3, type \PPOS to open the printer option setup menu.
2.
To use the decimal form, type \015 to specify condensed text.
LQ mode example
Suppose you are working in LQ mode and want to print text at 12 cpi.
In Appendix B you see that the decimal code for the command for 12
cpi is 27 77. Follow this procedure to specify 12 cpi printing in Lotus
1-2-3.
1.
In Lotus 1-2-3, type \PPOS to access the printer option setup menu.
2.
To enter the code in decimal format, type \027\077. Be sure to
insert the leading zeros before the numbers so they are both three
digits.

BJ mode command summary

All of the control codes shown in the following tables can be used in
the BJ mode.
Because of hardware differences, the reverse feed code — ESC ] and
the printer deselect code — DC3 — are not supported by your printer.
Also, the styles of block graphics characters at 12 cpi are different from
normal Proprinter X24E printing.
Appendix C Printer Command Summaries
C
115